Whenever you film with your DV camcorder, be sure you don't start beyond the last previously written time code segment.Then rewind and start your normal shooting, which will overwrite the previously recorded frames but maintain the time code structure. ![]() Put each tape in your DV camcorder with the lens cap on and record from start to finish.For this reason, it's good practice to maintain a continuous time code on each recorded tape. Studio handles time code breaks fairly well, but other programs don't-especially higher-end programs that use continuous time code for features like batch capture. ![]() If you start recording anew from that subsequent point, the camera restarts the time code from the beginning. If there is a break in time code, the camera starts counting again at 00:00:00:01, which means duplicate time codes and potential confusion.ĭuplications can occur, for example, when you watch video that you've recorded and play past the end point of the recorded video. Ideally, time code is consecutive from start to finish, so each frame is unique. ![]() Note that DV tapes don't come with time code embedded these codes are stored on the tape by the camera as you shoot. Time code gives your DV camcorder and programs like Studio the ability to locate and access any particular frame on the DV tape. As you shoot, your DV camcorder stamps each frame with a sequential time code that looks like this:
0 Comments
Leave a Reply. |